SOLARFOCUS vampair K 08, Руководство по установке

Страница: 30 / 40

7 Electrical connection
7.6.8 Device address of the electronics
module
The device address of the module can be adjusted
using the rotary switch S1.
Using the module as a ... Device address
Electronic Module D1 vamp
air
A
7.6.9 Electr. fuses in the electronics module
DANGER - a fuse replacement may only be
carried out on a disconnected 230 V AC power
supply by qualified personnel.
Fuse Rating Size Assignment
F1 0.4 AT 5x20 mm Primary-side
supply transformer
F2 4 AT 5x20 mm Relay outputs
F3 0.4 AT 5x20 mm Secondary-side
supply transformer
If fuse F1 or F3 is defective, a message will be shown
on the display of the control system
eco
manager- touch
:
Electronics module communication error
7.7 Outside temperature sensor - position
Fig. 2-42_001BM
7.8 Connecting the control to the internet
To enable the Internet connection of the eco
manager-
touch
boiler control, connect the Ethernet port X2 1
(type RJ45) on the bottom of the display by cable to a
network router.
The connection is required in order to use the following
functions:
–
mySOLARFOCUS app
– Weatherman function
– Screen IP-VNC - Remote access to the control
–
Sending e-mails
i
Additional information on these functions can
be found in the operation manual.
Display - Connections
Fig. 2-43: Connections on the underside of the display
7.9 Smart Grid Ready
The SG-Ready label is a label for heat pumps, the con-
troller of which meet the conditions for inclusion in a
future, intelligent power grid
(smart grid = SG).
30 Installation manual vampair