SMC Networks PSE20 A Series, Руководство по эксплуатации

Страница: 21 / 82

-20-
No.PS
※※
-OMW0005-A
[Measurement mode]
Detects the pressure after power is supplied, and indicates the display and switch operating status.
This is the basic mode; other modes should be selected for set-point changes and other function
settings.
Measurement mode screen
Channel selection
In measurement mode, the channel can be changed by pressing the UP button.
Measurement mode display and setting are set for each channel.
Normal operation mode
Differential pressure check mode
Press the
SET button
once.
Press the
SET button
between 1
and 3 sec. Press the
SET button
between 3
and 5 sec.
Press the
DOWN
button once.
[3 step setting
mode]
Set either of set
value or
hysteresis.
(Refer to page 25 )
[Simple setting
mode]
Select the set
value, hysteresis
and delay time.
(Refer to page 27 )
[Function
selection mode]
Change the
function settings.
(Refer to page 29 )
[Sub display
setting]
(Refer to page 49 )
[Other Settings]
•Channel scan
function
•Zero-clear function
•Key-lock function
(Refer to page
66 )

: The outputs will continue to operate during setting.

: If a button operation is not performed for a certain time during the setting, the display will flash.
(This is to prevent the setting from remaining incomplete if, for instance, an operator were to leave during setting.)

: 3 step setting mode, simple setting mode and function selection mode settings are reflected each other.