SMC Networks PSE20 A Series, Руководство по эксплуатации

Страница: 8 / 82

-7-
No.PS
※※
-OMW0005-A

Do not use a load which generates surge voltage.
When a surge-generating load such as a relay or solenoid is driven directly, use a product with a built-in surge
absorbing element.

The product is CE marked, but not immune to lightning strikes. Take measures against lightning strikes
in the system.

Mount the product in a place that is not exposed to vibration or impact.
Otherwise failure or malfunction can result.

Prevent foreign matter such as remnant of wires from entering the product.
Take proper measures for the remnant not to enter the product in order to prevent failure or malfunction.

Do not use the product in an environment that is exposed to temperature cycle.
Heat cycles other than ordinary changes in temperature can adversely affect the inside of the product.

Do not expose the product to direct sunlight.
If using in a location directly exposed to sunlight, shade the product from the sunlight.
Otherwise failure or malfunction can result.

Keep within the specified ambient temperature range.
The ambient temperature range is 0 to 50
o
C. Operation at low temperature (5
o
C or less) may cause damage or
operation failure due to frozen moisture in the air.
Protection against freezing is necessary.
Avoid sudden temperature change even within specified temperature.

Do not operate close to a heat source, or in a location exposed to radiant heat.
Otherwise malfunction can result.

Adjustment and Operation

Turn the power on after connecting a load.
Otherwise it can cause excess current causing instantaneous breakage of the product.

Do not short-circuit the load.
Although error is displayed when the load at the output part has a short circuit, generated over current may lead to the
damage of the product.

Do not press the setting buttons with a sharp pointed object.
It may damage the setting buttons.

If using the product to detect very small pressure rates, warm up the product for 10 to 15 minutes first.
There will be a drift on the display of approximate

1% immediately after the power supply is turned on, within 10
minutes.

Perform settings suitable for the operating conditions.
Incorrect setting can cause operation failure.
For details of each setting, refer to page
18 to 69 of this manual.

Do not touch the LCD during operation.
The display can vary due to static electricity.

Maintenance

Turn OFF the power supply before maintenance.
There is a risk of unexpected malfunction.

Perform regular maintenance and inspections.
There is a risk of unexpected malfunction.

Do not use solvents such as benzene, thinner etc. to clean the product.
They could damage the surface of the body and erase the markings on the body.
Use a soft cloth to remove stains. For heavy stains, use a cloth soaked with diluted neutral detergent and fully
squeezed, then wipe up the stains again with a dry cloth.