![background image](http://html.mh-extra.com/html/smc-networks/lecpa-series/lecpa-series_operation-manual_1299839077.webp)
- 76 -
may be dropped at stop (EMG).
15
.
Driver and its peripheral devices /Specific product precautions
15.1 Design and Selection
Warning
1. Be sure to apply the specified voltage.
Otherwise, a malfunction and breakage of the driver may be caused.
If the applied voltage is lower than the specified, it is possible that the load cannot be moved due to
an internal voltage drop. Please check the operating voltage before use.
2. Do not operate beyond the specifications.
It may cause a fire, malfunction or
electric actuator damage can result. Please check the
specifications before use.
3. Install an emergency stop circuit.
Please install an emergency stop outside of the enclosure so that it can stop the system operation
immediately and intercept the power supply.
4. In order to prevent danger and damage due to the breakdown and the malfunction of this
product, which may occur at a certain probability, a backup system should be established
previously by giving a multiple-layered structure or a fail-safe design to the equipment, etc.
5. If a fire or danger against the personnel is expected due to an abnormal heat generation,
ignition, smoking of the product, etc., cut off the power supply for this product and the
system immediately.
6. Moving element of the
electric actuator might pulsate when stopping without deviation of
pulse in the pushing in operation.
15.2 Handling
1. The inside of the driver and its connector should not be touched.
It may cause an electric shock or damage to the driver.
2. Do not perform the operation or setting of this equipment with wet hands.
It may cause an electric shock.
3. Product with damage or the one lacking of any components should not be used.
It may cause an electric shock, fire, or injury.
4. Use only the specified combination between the driver and electric actuator.
It may cause damage to the driver or the
electric actuator.
5. Be careful not to be caught or hit by the workpiece while the
electric actuator is moving.
It may cause an injury.
6. Do not connect the power supply or power on the product before confirming the area where
the work moves is safe.
The movement of the work may cause accident.
7. Do not touch the product when it is energized and for some time after power has been
disconnected, as it is very hot.
It may lead to a burn due to the high temperature.
8. Check the voltage using a tester for more than 5 minutes after power-off in case of
installation, wiring and maintenance.
Warning