-
35
-
No.JXC
※
-OMU0030-A
7.2 Setting of the speed and the acceleration
The speed and the acceleration can be set by using switch (k) to (n) in
each driving direction.
This setting of the speed and the acceleration applies to the driving of all
position number.
The speed and the acceleration cannot be set in each position number
respectively.
●
How to set the speed and the acceleration
According to the mode, the setting procedure of the speed and the
acceleration is different. And the application of the function of changed
setting is different.
The difference in the setting of the speed and the acceleration according to the mode is shown in the
table below.
Setting of the Speed
and the Acceleration
Manual mode(M)
Auto mode(A)
Method
Change the
switch (k) to (n)
1) Keep pushing Forward button (i)
and Reverse
button (j)
for 3 seconds or more.
2) Rotate the switch(k) to (n) while
“□”
(value
(or
“
-.
”
)) is lit in the 7-segment LED (f).
When changeable
Controller state
Always
(It is required that the
stroke study has been
completed.)
State in which
“□
.
”
(value (or
“
-.
”
)) is lit in the
7-segment LED (f).
Setting value
16 steps of speed and acceleration can be set.
The set value of the speed and the acceleration are different according to
the electric actuator. Refer to
“10. Initial setting value of electric
actuator
(LEM series)”
.
Change speed,
acceleration reflection
timing
Applied when the electric actuator is stopping.
Not applied when the electric actuator is driving. Applied after the electric
actuator stops.
Change speed,
acceleration applied
operation
Test run
Positioning operation by parallel I/O
(f)
(i)
(k)
(m)
(j)
(l)
(n)
