y
Fast Forward:
Pressing the
button plays video forward at high speed. Pressing the button again
toggles the playback speed from
,
and
. The screen displays
,
and
respectively and the status display panel displays
. The button on the front panel is also used for Far
Focus while in the PTZ mode.
y
Backward:
Pressing the
button goes to the previous image. The button on the front panel is also
used to save Presets while in the PTZ mode.
y
Forward:
Pressing the
button goes to the next image. The button on the front panel is also used to
load a Preset View in the PTZ mode.
Panic Button
Pressing the
button starts panic recoding of all camera channels, and displays on the screen and
on the status display panel. Pressing the button again will stop panic recording.
ALARM Button
The
button has two functions. First, it will reset the DVR’s outputs including the internal buzzer
during an alarm. Second, it will display the event log when you are in the live monitoring mode unless
there is an active alarm. This operation can be user password protected.
Shuttle Ring
The Shuttle Ring only functions in the Playback mode. The Shuttle Ring is spring loaded and returns to
the center position when released. Turning the ring clockwise plays video forward. Turning the ring
counterclockwise plays video backward. Playback speed varies with the amount the ring is turned. The
playback speeds are
,
,
, x0.5, ,
,
and
.
When you release the ring, it snaps back to the center position and the video pauses.
Jog Dial
When in the playback mode, you can play video forward image-by-image by turning the Jog Dial
clockwise and backward image-by-image by turning the Jog Dial counterclockwise.
When in the PIP mode, you can make the PIP screen smaller by turning the Jog Dial clockwise and larger
by turning the Jog Dial counterclockwise.
When in the Setup mode, you can change number values by highlighting the item in the menu and turning
Jog Dial clockwise or counterclockwise to increase or decrease the number.
ID Button on Remote Control
If a DVR System ID is set to 0, the infrared remote control will control that DVR without any additional
operations. (Refer to the
System Information
setup screen in this chapter for further information on
setting the System ID.) If the system ID is 1 to 16, you must to press the
ID
button on the remote control
and then press the number button (1 to 16) in order to control that DVR. If the System ID of two or more
DVRs is set to 0, those DVRs will react to the infrared remote control at the same time.
