SMART Embedded Computing COMX-CORE-2610-ET, Инструкция по установке и эксплуатации

Страница: 37 / 92

Installing and Removing COM Express Module to/from the Carrier Board
COMX-CORE-2610-ET Installation and Use (6806800P11E) 37
2.5 Installing and Removing COM Express Module
to/from the Carrier Board
This section provides the steps for installing the COM Express module assembly (with heat
spreader or heat sink assembly) to the carrier board and removing the COM Express
module from the carrier board.
2.5.1 Installation
1. Line up the board-to-board connector of the COM Express module with the board-to-
board connector of the carrier board.
2. Make sure that the interconnectors are properly aligned and that the bottom of the
COM Express module has contact with the five standoffs on the carrier board.
3. From the top-side of the COM Express module assembly, locate the five COM Express
module mounting holes.
4. Use the screws to fasten the COM Express module assembly with the carrier board.
Figure 2-3 Installation and Removal