33
SKOPE TME-N ActiveCore
Replacement Procedures
Service Manual
Sign Light
The sign is lit by an LED modular light which can be replaced by following
the steps below.
To replace the sign light
1. Disconnect the chiller from the power supply.
2. Undo the two fixing screws from the sign top cover and remove the top cover.
3. Remove the front sign panel/decal by sliding them up and out of the sign.
4. Remove the sign cover from the top of the sign.
5. Remove additional sign panel by sliding up and out of the sign.
6. Cut the cable tie holding the light cable at the back of the sign.
7. Undo the two most RH sign
reflector screws.
8. Carefully pull the light plug
and cable through to the
front of the sign,
manipulating the reflector
as required.
9. Unclip and replace the light.
10. Rout the light plug and cable back through behind the reflector and hole at the
back of the sign, and cable tie in place.
11. Reassemble the sign, reconnect to the power supply and check for correct
operation.
Light
Light cable
(pulled through
to front)
Reflector
Reflector screws
(removed)