29
SKOPE TME-N ActiveCore
Installation
Service Manual
Shelves
The chiller is fitted with five wire shelves per door, which may be positioned
at different heights to suit various products
Shelf Clips
Each wire shelf is held in place with four shelf clips, which engage in the
shelf support strips and slide up and down to the desired shelf position.
The support strips are numbered for easy location of shelf clips. View the
numbers in the bottom LH corner of the shelf clip.
To fit a shelf clip
To adjust the shelf clip height
To remove a shelf clip
Repositioning
Shelves
When repositioning standard shelves, unload and remove the shelf,
establish the desired position and slide the shelf clip in each of the shelf
support strips to the desired position (see “To adjust the shelf clip height” on
page 29). Sit the shelves on the shelf clips.
1. The shelf clip twists onto
the shelf support strip.
Position the shelf clip
with the flat side up
against the shelf support
strip and the two prongs
pointing up. Twist the top
of the clip anticlockwise
onto the shelf support
strip until it locks in
place.
1. Pull the shelf clip tab up
and slide the shelf clip
up or down as required.
Once in position, ensure
the shelf clip is locked
into place.
1. Pull the shelf clip tab up and twist the top of the clip clockwise off the shelf
support strip.
Shelf
support
strip
Prongs
Shelf clip
Shelf clip
Tab
