Sirona sirolaser blue, Руководство по эксплуатации

Страница: 15 / 58

60 90 570 D 3485
D 3485.201.04.09.02
09.2007
15
3 Introduction
båÖäáëÜ
båÖäáëÜ
CAUTION
Following transport and storage, allow the laser unit to acclimate for about
1 hour in order to reduce the risk of malfunction due to condensation.
3.4 Precautions
Using controls or settings or performing functional tests other than those
specified in this manual may result in hazardous radiation exposure.
Sirona Dental Systems GmbH cannot be held liable for any damage caused
by improper use or non-compliance with the instructions and information pro-
vided in this manual.
Please remember the following:
CAUTION
SIROLaser may only be operated by trained and qualified personnel.
CAUTION
Laser equipment not in use must be protected against unauthorized access.
This can be achieved for example by switching off the laser unit after use,
so that the electronic access key must be entered prior to further operation.
Set up the SIROLaser laser unit properly and completely before putting it into
operation (see chapter 4).
Make sure that the electrical system is equipped with the required devices for
protection against direct and indirect contact (thermomagnetic switches,
residual current circuit-breaker) and has been set up by a qualified electrician
in compliance with the applicable standards.
National regulations concerning electrical installations shall be obeyed.
Verify that the line voltage corresponds to the voltage indicated on the rating
plate of the switching power supply or in the technical specifications.
WARNING
Do not use the laser unit if a visual inspection reveals damage.
WARNING
Do not use the laser unit in the presence of flammable materials.
If you accidentally spill liquid on the unit, immediately stop treatment, discon-
nect the power supply cable and contact your local dental distributor or autho-
rized service center for assistance.
CAUTION
Do not attempt to disassemble the laser unit in any case. This is limited exclu-
sively to trained and authorized personnel.
Do not place the laser unit near heat sources.
Do not cover the convection openings for air cooling on the sides of the unit.