21
1.
disinsert the plug from the outlet and
carefully clean the blade with denatured
alcohol so it is degreased;
2.
lift (a) the sharpener cap (1) and turn it
180° (b Fig. n°43);
5.3 - SHARPENING THE BLADE
WARNING: Before starting to sharpen the blade, pay attention to RESIDUAL RISKS
(chapter 4.2.2) concerning the dangers of cutting without having followed the
instructions listed below.
To sharpen the blade, which needs to be done periodically as soon a decrease in cutting is
noticed, the following directions must be adhered to:
3.
4.
let it go in a way that the cap (c) fits on
the locator pins (d Fig. n°44);
check also that the blade stays between
the two grinders;
5.
insert the pin and start the machine, by
pressing the “ON” push-button;
6.
press the push-button (2 - Fig.n°45), let
the
blade rotate in contact with the grinder
for
about 30/40 sec. so that a slight burr
forms
on the blade edge;
7.
8.
9.
press the 2 push-buttons (2 and 3)
contemporaneously for 1/2 sec. and
release them in the same instant (Fig. n°
46);
after having completed the sharpening it
is
advisable to clean the grinders and the
blade (chapter 6.2.3);
once the operation is finished, replace the
sharpening device in its original position,
doing the procedure in reverse.
N.B.: Do not carry on the deburring
operation for more than 1/2 sec. to avoid
the
damaging bending of the blade edge.
b
a
1
Fig. n°43
Fig. n°44
Fig. n°45
c
d
2
3
2
Fig. n°46
