10
2.3.5 - Electrical connection modification
Unless otherwise specified, the slicers are equipped with 400 V. three-phase connection. To
modify the connection carefully follow these instructions:
-
remove the plug from the electric network;
-
turn the slicer on the side opposite the trolley;
-
take off the yellow cover from the electrical box;
-
remove the motor cables from the electronic card;
-
connect wires from the motor that have the same color (white-white, blue-blue, etc.);
-
reconnect them to the electronic card;
-
check the positioning of the feed selection plugs on the electronic card (Fig. n°21);
-
close the box, reposition the slicer and proceed as in paragraph 2.3.3.
2.4 - PRELIMINARY CHECK
Before testing make sure the goods holder plate
is well-blocked, after which test functioning
with the following procedure:
-
Push the “ON” push-button and the “OFF”
push-button Fig. n°22;
-
check if by unscrewing the blade guard tie
rod
the machine stops working;
-
Check if the machine does not start
automatically by removing the plug and
reinserting it while the machine is running.
Fig. n°22
“ON” button
“OFF” button
Fig. n°21
2.4.1 - Cleaning and maintenance of the controls
The buttons fitted on this machine are of an extremely high quality standard and can be
washed with water as they have a class IP67 protection rating.
Should they get clogged or jammed after being touched with dirty hands, do not use knives or
sharp tools to try to release them.
WARNING! Pull out the power plug before every cleaning operation, transfer the machine to an
adequate location and spray the buttons with hot water (avoid high-pressure jets).
Be CAREFUL not to let any water penetrate into the other parts of the machine, for reasons of
electrical safety and to preserve the machine’s working life.
This operation should soften the grease and dirt, releasing the button.
Once the buttons have been released, press them several times (with the plug detached) in order
to expel any remaining dirt inside them. If the operation fails from the beginning, repeat the washing
operation several times until the buttons have flushed out all the dirt. Alternatively, prevent use of
the machine and contact the Service Centre to replace the buttons.
Buttons that have been scratched or tampered with using blunt tools shall not be covered by the
warranty.
