23
N.B. The bladeguard must be cleaned with
warm water, the equipped detergente or with
neutral detergent (pH 7).
6.2.3 - Cleaning the sliceguard
(Fig. n°52)
To remove the sliceguard simply grasp the
hand grip (1) and pull up so that the two pins
unhook (2), and then extract the sliceguard. At
this point clean the sliceguard with warm water,
the equipped detergent or with neutral detergent
(pH 7).
6.2.4 - Cleaning the sharpener
To clean the sharpener it is necessary to
adhere to the following instructions:
1.
lift (a) the cap up to the top;
2.
loosen the knob (1);
3.
lift (b) the cup (2) and extract it so that
the
knob (1) passes through the larger
opening
in the cup (2);
4.
rub the grinders with a brush, while
cleaning the other components with warm
water, the equipped detergent or with
neutral detergent (pH 7).
the following way:
1.
2.
unhook the bladeguard (Fig. n°49);
take out the sharpening device (Fig. n°51
ref.a) and open, by using the graduated
hand grip, the thickness gauge enough to
make the jig (Fig. n°51 rif.b) stick to the
blade;
3.
unscrew the three or four screws (Fig. n°51
ref.f), depending on the model, which
fasten
the blade;
4.
rest the jig (b) on the blade, so that the
split
in the jig fits in the ring (Fig. n°51
ref.c);
5.
match the axes of the two holes (Fig. n°51
ref.d) on the blade with the twoknobs
(Fig. n°
51 rif.e) on the jig, simply making
the blade
turn to the desired position;
6.
screw the two knobs (e) without
excessively tightening them.
Fig. n°50
d
c
e
f
b
a
Fig. n°51
1
2
b
Fig. n°54
1
2
2
1
Fig. n°52
a
Fig. n°53
