8
2.2 - POSITIONING
Position the pallet, with the slicer, on a flat
surface and take off (a) the cap from the slicer
(Fig. n°12).
At this point turn the machine on its side (Fig. n°
13) and unscrew, with the proper wrench
provided, the 4 nuts which fasten the slicer.
Remove the 4 washers and unscrew the 4
fastening tie rods on the wooden pallet. Take off
the pallet and fasten the 4 feet provided. Finally,
put the cap in its place.
Position the slicer in the predestined place. The
dimensions indicated in Tab. 1-2-3 (according
to the model) must be kept in mind for the plane
where the slicer will be installed, therefore it must
be wide enough, well-levelled, dry, smooth,
robust, stable about 80 cm high off the ground
and at least 20 cm from walls, objects, shelves,
etc. (Fig. n°14) in respect to the space necessary
for its use and safeguarding.
Furthermore the machine must be placed in an
environment with a maximum humidity of 75%,
not salty and with a temperature between
+5°C and +35°C; in any case in environments
which do not lead to deviations of the above.
Make sure the graduated hand grip is in
posiion “0”.
Check the alignment of the blade-plane
thickness gauge by running a finger (Fig. n°16)
6)
from the blade ards the thickness
gauge
plane (never in the opposite direction).
Unscrew
and screw the feet on the operator’s
side until the
correct alignment is found (Fig.
n°17).
a
~ 80cm
Fig. n°12
Fig. n°13
Fig. n°14
Fig. n°15
Fig. n°16
Fig. n°17
20cm
20cm
20cm
