20
TRIUMPH FAN MODEL INSTALLATION
4.
Mount Assembly from Step 3 to fan
housing in position shown. Utilize
washers and bolts from Step 1. Verify
burner is centered over opening. Finish
tightening ¼” hardware from Step 3 after
final adjustments for positioning of
Burner Assembly is made. Insert and
tighten remaining 5/16” washer and bolts
in their original holes from Step 1.
5.
For EQM version of heater only (Heater Model S224443). Proceed to next step for Thermostat version
(Heater Model S224444).
a.
Install Temperature and Relative Humidity Sensor inside control box (sensor will be found inside
box). Sensor will need to be inserted in small hole found in bottom of box. The Sensor Filter,
found at end of sensor, must be removed prior in insertion and then re-attached. Mount sensor to
bottom of box using the three holes and screw provided.
Remove Sensor Filter
Inset Sensor & Reattach Filter
Mount Sensor
6.
Position Control Box Assembly on top
of fan as shown aligning mounting holes
of control box base with 9/32” holes drilled
previously. If control box is equipped with
sensor, insert sensor in 7/8” hole. Secure
control box to fan housing using (4x) 5/16”
x ¾” Self-Forming Screws.
