Simrad TV80, Справочное руководство

Страница: 63 / 306

406388/B
61
Defining the serial line communication parameters for the PI50
and PI60 Receiver Units
The communication between the PI50 and PI60 Receiver Units and the Processor Unit
is made using a (1:1) serial line. All serial line communication is based on specific
transmission parameters. These parameters must be defined at each end of the line, and they
must be set up identical.
Prerequisites
The Receiver Unit is physically connected to the Processor Unit using a serial cable.
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
3 Observe the
I/O Setup
page on the right side of the
Installation
dialog box.
Every interface is presented as a small "block diagram".
4 In the relevant block diagram, select the serial port icon.
Observe that the
Serial Port Setup
dialog box opens.
5 Make the necessary adjustments.
The communication parameters defined for the PI50 and PI60 Receiver Units are:
•
Baud rate
: 4800 b/s
•
Data bits
: 8
•
Parity
: None
•
Stop bits
: 1
6 Select
OK
to save the chosen settings and close the dialog box.
Getting started