Simrad TV80, Справочное руководство

Страница: 43 / 306

406388/B
41
3 Observe the
I/O Setup
page on the right side of the
Installation
dialog box.
4 Observe that the available serial interface ports on the Processor Unit
are listed.
Next to every port icon, a green indicator shows it is available, while a
red one shows it is not available.
5 Select the serial port the receiver is connected to.
6 In the
Select Input (Serial)
dialog box, select the receiver you wish to connect to, and
then select
OK
Result
Every new interface is presented as a small "block diagram" on the
I/O Setup
page.
The block diagram shows you (from right towards left) the
serial port, the sensor receiver and the hydrophone. The
I/O
Setup
page also presents a number of "inspection points".
By selecting an inspection point you can retrieve relevant information about the connection.
Defining the serial line communication parameters for
navigation sensors and external devices
Serial line communication is important for TV80 operation. All serial line communication is
based on specific transmission parameters. These parameters must be defined at each end of
the line, and they must be set up identical. By means of the
Serial Port Setup
dialog box, you
can define these parameters manually to match fixed parameters on the peripheral device.
Prerequisites
• The new device is physically connected to the Processor Unit using a serial cable.
• The new device is physically available, and operational.
• The communication parameters required for the device interface are known.
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
3 Observe the
I/O Setup
page on the right side of the
Installation
dialog box.
Every interface is presented as a small "block diagram".
Getting started