Simrad TV80, Справочное руководство

Страница: 44 / 306

42
406388/B
4 In the relevant block diagram, select the serial port icon.
Observe that the
Serial Port Setup
dialog box opens.
5 Make the necessary adjustments.
The communication parameters defined for
NMEA 0183
are:
•
Baud rate
: 4800 b/s
•
Data bits
: 8
•
Parity
: None
•
Stop bits
: 1
Some instruments may offer other parameters and/or choices. You must always check
the relevant documentation provided by the manufacturer.
6 Select
OK
to save the chosen settings and close the dialog box.
Defining receiver parameters for the PI50 and PI60 Receiver
Units
The
Receiver
dialog box allows you to set up the detailed parameters for the signal reception.
It allows you to "fine tune" the receiver for optimal performance. Sea conditions will vary,
and the acoustic conditions are also changing.
Prerequisites
This procedure assumes that a receiver has been connected to the Processor Unit by means
of a serial line, and that the communication line has been initiated.
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
3 Observe the
I/O Setup
page on the right side of the
Installation
dialog box.
Every interface is presented as a small "block diagram".
Simrad TV80 Reference Manual