Simrad SP60 - REV D, Руководство по установке

Страница: 141 / 218

Testing the peripheral equipment
125
851-164574 / C
10.2 General
Default interface settings
The sensor settings are all preset to these recommended
connections.
Sensor Type Port Baudrate Talker
Trawl system ITI 6 4800 None
FS 6 4800 None
Echo sounder NMEA 5 4800 None
Purse seine system PI30 6 4800 None
Position system GPS 4 4800 None
Speed log SpeedLog 9 9600 SS
Heading Gyro 3 4800 None
Hull unit
Stabilization
Weather
Wind 4800 None
Changing the interface settings
To change any of the interface settings, observe the following
procedure.
1 Select the Setup menu.
2 Press the Test... button to open the System Test menu.
3 Press the Installation Menu button.
4 Observe the Installation menu appear on the top of the
display.
5 Select I/O Setup on the Installation menu , and then
Sensors .
6 Observe a submenu listing all the available sensors.
7 Move the cursor down on the submenu, but do not press the
Select button on the Operating Panel.
8 Observe that each sensor has a new submenu listing the
default choices or
None . The chosen setting is marked.
9 Select None if you wish to disable the sensor input.
10 Select any of the other settings if you wish to define the
sensor interface parameters.
11 Observe the Sensor Config submenu appear at the bottom
of the menu field.
12 Make the appropriate settings for the sensor.