Simrad SC90, Руководство по установке

Страница: 336 / 544

334
419050/B
A
Bow & 0
°
motion sensor
B
This is the offset angle
C 0
°
transducer mark
Procedure
1 Select the
Setup
tab to
open the menu.
2 Select
Test
on the
Setup
menu to open the
System
Test
menu.
a Write down the roll
compensation value
in the
Roll
"button".
b Write down the pitch
compensation value
in the
Pitch
"button".
3 Open the
Installation
menu.
a Select the
Setup
tab
to open the menu.
b Select
Test
on the
Setup
menu to open
the
System Test
menu.
c Select
Installation
menu
to open the
menu.
d Observe that the
Installation
menu opens across the top of the SC90
presentation.
4 On the
Installation
menu, select
Installation
→
I/O Setup
→
Sensors
.
a On the submenu, select
Stabilization
.
b Select
External
.
c Observe that the
Sensor Configuration
parameter dialog box opens.
d Select the serial port you wish to use.
e Set up the relevant port parameters.
f Specify the timeout value.
g Specify if the input shall be Automatic or Fixed .
h Select
Close
to save the settings and close the parameter dialog box.
Note
Once you close the
Sensor Configuration
parameter dialog, the chosen
communication port will "disappear". If you later need to change
the communication parameters, you must first choose internal sensor
(select Transceiver1), and then restart the SC90.
Simrad SC90 Installation Manual