Simrad SC90, Руководство по установке

Страница: 151 / 544

419050/B
149
Procedure
1 Remove the top cover of the wooden transport
box.
2 Pull out all the nails marked with Indian ink.
3 Remove the support hardware (wooden cradle and
support construction).
If you wish to reuse the transport box, make sure
that you keep all the support hardware used to
secure the hull unit.
4 Fasten the lifting tackle to the two lifting eye bolts
on either side of the top of the gantry.
5 Lift the hull unit ( with the transducer protection still in place! ) carefully out of
the transport box.
Note
Verify that you use the correct lifting eye! There are two lifting eyes on each side
of the hull unit. One is located on the top of the gantry, and one on the top of the
transducer shaft. Make sure that you use the lifting eye on the gantry when you lift
the hull unit out of the transport box!
6 While lifting, make sure that you do not damage the delicate parts of the hull unit.
Note
Make sure that you keep the transducer safe, and the transducer cable and
connector dry. Watch these carefully to prevent these delicate parts from being
damaged, stuck or hooked on to protruding objects while manoeuvring the hull unit
into the sonar room. Do not remove the transducer protection (the thick foam) until
just before the hull unit is lowered onto the installation trunk.
Installing the SC90 Hull Unit