Simex SRD-99, Руководство пользователя

Страница: 10 / 112

User manual - DATA RECORDER SRD-99 and cooperating software
4. DEVICE INSTALLATION
The unit has been designed and manufactured in a way assuring a high level of user
safety and resistance to interference occurring in a typical industrial environment. In order to
take full advantage of these characteristics installation of the unit must be conducted correctly
and according to the local regulations.
- Read the basic safety requirements on page 4 prior to starting the installation.
- Ensure that the power supply network voltage corresponds to the nominal
voltage stated on the unit’s identification label.
- The load must correspond to the requirements listed in the technical data.
- All installation works must be conducted with a disconnected power supply.
- Protecting the power supply connections against unauthorized persons must be
taken into consideration.
4.1. UNPACKING
After removing the unit from the protective packaging, check for transportation damage.
Any transportation damage must be immediately reported to the carrier. Also, write down the
unit serial number located on the housing and report the damage to the manufacturer.
4.2. ASSEMBLY
- The unit is designed for mounting inside housings (control panel, switchboard)
inssuring appropriate protection against surges and interference. Metal housings
must be connected to ground in a way that complies with the governing
regulations.
- Disconnect the power supply prior to starting assembly.
- Check the connections are wired correctly prior to switching the unit on.
In order to install the unit, a 90,5 x 90,5 mm mounting hole ( Fig. 4.1 ) must be
prepared. The thickness of the material of which the panel is made must not exceed
5mm. When preparing the mounting hole take the grooves for catches located on
both sides of the housing into consideration (
Fig. 4.1
). Place the unit in the
mounting hole inserting it from the front side of the panel, and then fix it using the
brackets (
Fig. 4.3 ). The minimum distances between the center points of multiple
units - due to the thermal and mechanical conditions of operation - are 115 mm x
115 mm (
Fig. 4.5 ).
10
!
!