Silicon Graphics InfiniteStorage 4000 Series, Настройка и обслуживание

Страница: 37 / 276

Chapter 2: About the Script Commands 25
Statement data is in the form of:

Parameter = value (such as
raidLevel=5
)

Parameter-name (such as
batteryInstallDate
)

Operation-name (such as
redundancyCheck
)
A user-defined entry (such as user label) is called a variable. In the syntax, it is shown
in italic (such as
trayID
or
volumeGroupName
).
Synopsis of the
Script
Commands Because you can use the script commands to define and manage the different aspects
of a storage array (such as host topology, drive configuration, controller
configuration, volume definitions, and volume group definitions), the actual number
of commands is extensive. The commands, however, fall into general categories that
are reused when you apply the commands to the different tasks to configure or
maintain a storage array. The following table lists the general form of the script
commands and a definition of each command.
Table 3 General Form of the Script Commands
snapshot
(legacy)
Volume user label
storageArray
Not applicable
tray
Tray ID
volume
Volume user label or volume World Wide Identifier
(WWID) (
set
command only)
volumeCopy
Target volume user label and, optionally, the source
volume user label
volumeGroup
User label
Valid characters are alphanumeric, a hyphen, and an
underscore.
Object Type Identifier
Syntax Description
accept object

{ statement-data }
Perform the pending operation.
activate object

{ statement-data }
Sets up the environment so that an operation can take
place or performs the operation if the environment is
already set up correctly.
autoConfigure storageArray

{ statement-data }
Automatically creates a configuration that is based on
the parameters that are specified in the command.