Siemens 8DJH, Инструкция по установке и эксплуатации

Страница: 50 / 174

5 | Transport
50/174 8DJH • Installation and Operating Instructions • Version 11 • 500-8384.9
Performing the transport
1. Attach the lifting gear or insert the crane rod.
2. Transport the switchgear. While lifting, observe the accessories lying in the cable
compartment.
3. Lift and lower slowly, as the switchgear will swing into the center of gravity when it is lifted.
5.5 Unpacking the switchgear for installation
NOTICE
Environmental pollution by packings and consumables
Incorrectly disposed of packings and consumables can pollute the environment.
⇨ Packings and consumables of the switchgear must be disposed of in an environmentally
compatible way or recycled.
⇨ Observe local regulations for disposal and environmental protection.
1. If required, remove seaworthy or latticed crate.
2. Remove the PE film.
3. If required, removing the cable compartment cover and take out the accessories. Hook the
cable compartment cover in again.
4. If the switchgear can be lifted directly from the wooden pallet onto its mounting position,
remove the transport angles.
If the switchgear cannot be lifted directly from the wooden pallet onto its mounting position:
5. Remove the transport angle from the transport pallet.
6. Lower the transport units by means of the lateral transport angles onto roller pads
(reinforced rollers) or tubes.
7. Lift the switchgear at the side edges with roller crowbars and slowly lower it onto the
mounting position.
8. Remove the transport angles from the switchgear.
Removing the transport angles
The panels are fixed on the wooden pallets with transport angles on the sides.
1. Unscrew all fixing bolts of the transport angles and remove the transport angles.
2. Screw the fixing bolts of the transport angles in again on
both sides of the panels.
Fig. 26: Transport angle for wooden pallet Fig. 27: Fixing points for transport angles (on
both sides)