Chapter 10
Operating Instructions
ICR845-2 Image Code Reader
154
©
SICK AG · Division Auto Ident · Germany · All rights reserved
8012377/ 0000/ 2008-01-30
Appendix
Selecting the Dynamic Teach-in:
1.
Select the D
EVICE
C
ONFIGURATION
tab.
2.
Click the M
ATCH
C
ODE
P
ARAMETERS
button.
The M
ATCH
C
ODE
P
ARAMETERS
tab is then displayed.
3.
Click the D
YNAMIC
radio button in the M
ETHOD OF TEACH
-
IN
section.
Configuring match code 1 for output filter (optional):
1.
Select the M
ATCH
C
ODE
P
ARAMETERS
tab.
2.
Proceed as follows to activate the output filter in the C
ODE
A
CTIVE
section:
– Click the C
ODE
#1 checkbox.
– Click the F
ILTER FOR
H
OST
O
UTPUT
checkbox.
– Click the C
ODE
#1 checkbox again.
The code comparison activated via the user interface is now no longer permanently
activated. The output filter, however, remains active.
Important
If two match codes have been defined and activated, the activation of one of the match co-
des for output filter determines that the ICR845-2 only outputs codes which match with the
code for output filter via the host interface.
If the ICR845-2 also reads codes which match with the other match code, the output of the-
se codes will be suppressed.
Example:
Match code 1 = Code 39, content: 12345, output filter active
Match code 2 = 2/5 Interleaved, content: 777
ICR845-2 reads two codes, both codes match each one of the defined match codes.
ICR845-2 only outputs: 12345
Deleting an existing match code 1 (optional):
1.
Select the M
ATCH
C
ODE
P
ARAMETERS
tab.
2.
Click the D
ELETE LAST MATCH CODE AT NEW TEACH
-
IN
checkbox in the S
PECIAL FUNCTION
sec-
tion.
Configuring "Sensor 2" switching input for teach-in trigger:
1.
Select the D
EVICE
C
ONFIGURATION
tab.
2.
From the A
SSIGNMENT
drop-down list in the S
ENSOR
2 section, select the M
ATCHCODE
T
EACH
-
IN
option.
Configuring reading pulse trigger (optional):
1.
Select the D
EVICE
C
ONFIGURATION
tab.
2.
Click the R
EADING
T
RIGGER
P
ARAMETERS
button.
3.
Click the S
ERIAL
I
NTERFACE
radio button in the S
TART OF READING INTERVAL
section (for this
example).
Configuring the switching outputs for indication of result status:
1.
Select the D
EVICE
C
ONFIGURATION
tab.
2.
Click the R
ESULT
O
UTPUT
P
ARAMETER
button.
3.
In the dialog box under R
ESULT
F
UNCTIONS
, choose e.g. the M
ATCH
1 option for Result 2
(LED "Result") in the drop-down list.