SHINING 3D - EinScan-Pro series - User Manual - June 2019
110
11.1.4.
Firmware Upgrade
When the scanner is connected for the first time with the HD Prime Pack attached,
the scanner might require a firmware upgrade.
❌
Important:
Make sure the scanner is connected well and do not disconnect the device.
If there is a power failure or the connection is cut off during this process, please contact
technician via [email protected]
If the upgrade went wrong and the Scanner in HD Prime mode only shows 7 lines instead of
64 you have to upgrade manually with the firewire_upgrate_tool.exe in the EinScan folder.
11.1.5.
Calibration
Calibration should be performed every time you plug in the HD Prime Pack to insure
the correct matching with EinScan.
Calibration with Prime
Use the front side (Black) of the calibration board for Prime calibration. In the
calibration interface, run the Calibration with the normal method (see “camera
calibration”)
If the calibration keeps failing, check whether the Prime is well locked in position.
After calibration, perform the Accuracy test or click Next to go back to the Mode
selection menu.
11.2.
Before scan
When prime is plugged, “HD Scan” becomes “HD Scan with Prime”. Other modes are
not using Prime (refer to previous sections for Fixed and Rapid mode).
Содержание EinScan Pro
Страница 17: ...SHINING 3D EinScan Pro series User Manual June 2019 17 EXScan Pro on the start menu ...
Страница 30: ...SHINING 3D EinScan Pro series User Manual June 2019 30 Add on is required for this function ...
Страница 41: ...SHINING 3D EinScan Pro series User Manual June 2019 41 4 4 Scan Workflow ...
Страница 52: ...SHINING 3D EinScan Pro series User Manual June 2019 52 Browse to load a GMF ...