E-28
SD-AT100W(X)E3.fm
02/2/27
SD-AT100W
ENGLISH
4
B
asic Ope
ration
- L
ist
en
in
g
t
o
t
h
e memo
ri
se
d
st
at
io
n
-
Listening to the memorised station
"
Memorising a station
(Remote control operation)
You can store 40 AM and FM stations in memory and recall them at the push of a
button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or the AC power lead disconnection.
"
To erase all the contents of the preset
memory
(Remote control operation)
"
To recall a memorised station
"
Setting the AM/FM interval (valid only in
some areas)
The AM/FM span can be changed in some areas.
Before using the unit, be sure to set it to the AM/FM tuning interval (span) used in
your area.
To change from a 9 kHz AM (50 kHz FM) interval to a 10 kHz AM (100
kHz FM) interval:
To return to a 9 kHz AM (50 kHz FM) interval:
Caution:
!
When the unit is left for a few hours after the span has been switched and the AC
power lead disconnected, the AM span will be automatically returned to 9 kHz (FM
span to 50 kHz). If this happens, set the span again.
!
When the span is switched, all the memorised stations will be cancelled.
1
Perform steps 1 - 3 in "Listening to the radio" on page 27.
2
Press the ENTER button to enter the preset tun-
ing saving mode.
3
Within 5 seconds, press the TUNER PRESET (
or ) button to select the preset channel num-
ber.
Store the stations in memory, in order, starting with preset channel 1.
4
Within 5 seconds, press the ENTER button to
store that station in memory.
If the "MEMORY" and preset number indicators go out before the station is
memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
When a new station is stored in memory, the station previously memorised will
be erased.
1
Press the TUNER (BAND) button.
2
Hold the CLEAR button down for 3 seconds
or more.
3
Whilst "CLEAR" is displayed, press the EN-
TER button.
(Remote control operation)
Press the TUNER PRESET ( or ) button to select the desired sta-
tion.
Preset channel
Frequency and frequency band
1
Press the ON/STNA-BY button to enter the stand-by mode.
2
Hold down the
button and the
button for at least 4 seconds. Release the
buttons when "AM SP 10 kHz" and "FM SP 100 kHz" are displayed alternately.
1
Press the ON/STNAD-BY button to enter the stand-by mode.
2
Hold down the
button and the
button for at least 4 seconds. Release the
buttons when "AM SP 9 kHz" and "FM SP 50 kHz" are displayed alternately.
Downloaded from:
