Sharp AX-1100R, Руководство по эксплуатации с кулинарной книгой

Страница: 55 / 104

EN – 3
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity, and the feature sticker from the outside of the door, if
there is one. Check the unit for any damage, such as a misaligned door, damaged door seals around the
door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven
until it has been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1) Rack 2) Glass tray 3) Steam tray 4) Combined operation manual and cookbook 5) Touch guide
3. Since the door may become hot during cooking, and in order to avoid its accidental touch, the oven should
be placed at least 85 cm or more above fl oor. You should also keep children away from the door to prevent
them burning themselves.
4. This oven is designed to be used on a countertop only. It should not be installed in any area where excessive
heat and steam are generated, for example, next to a conventional oven unit. It should not be installed near
combustible materials, for example, curtains. The oven should be installed so as not to block ventilation
openings. Allow space of at least 12 cm from top of the oven for air ventilation. This oven is not designed to
be built-in to a wall or cabinet.
5. Do not connect other appliances to the same socket using an adaptor plug.
6. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure. The A.C. voltage and frequency must
correspond to the one indicated on the rating label.
7. This appliance must be earthed:
IMPORTANT
The wires in power supply cord are coloured in accordance with the following code:
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wires in the power supply cord of this appliance may not correspond with the coloured
marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol
or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured brown.
SRH AX1100R̲en.indd 3 SRH AX1100R̲en.indd 3 2011/10/25 15:08:50 2011/10/25 15:08:50