SEW-Eurodrive MM 03D-233-00, Краткое руководство по эксплуатации

Страница: 71 / 80

7
Service
Error list
Compact Operating Instructions – MOVIMOT
®
MM..D with AS-Interface
71
Code Error Possible cause Measure
07 DC link voltage too
high Ramp time too short. Extend the ramp time.
Reset the fault
1)
.
Faulty connection between
brake coil/braking resistor Check the braking resistor/brake coil connec-
tion. Correct, if necessary.
Reset the fault
1)
.
Incorrect internal resis-
tance of brake coil/braking
resistor Check internal resistance of brake coil/braking
resistor (see operating instructions, chapter
"Technical data").
Reset the fault
1)
.
Thermal overload in brak-
ing resistor, wrong size of
braking resistor selected Dimension the braking resistor correctly.
Reset the fault
1)
.
Invalid voltage range of
supply input voltage Check supply input voltage for permitted
voltage range.
Reset the fault
1)
.
08 Speed monitoring Speed deviation due to
operation at the current
limit Reduce the load on the drive.
Reset the fault
1)
.
09 Startup Improper drive ID module
for MOVIMOT
®
with 230 V
supply
For MOVIMOT
®
with 230 V supply, not all
drive ID modules are permitted (see operating
instructions, chapter "Assignment of the drive
ID module").
Check/correct the drive ID module.
The additional functions 4,
5, 12 are not permitted for
MOVIMOT
®
MM..D with
AS-Interface.
Correct the settings of DIP switches S2/5 –
S2/8.
Firmware does not support
MLK..A option (only for
MOVIMOT
®
with AS-Inter-
face).
Contact SEW-EURODRIVE Service.
11 Thermal
overload of the out-
put stage
or internal unit error Heat sink is dirty. Clean the heat sink.
Reset the fault
1)
.
Ambient temperature too
high. Lower the ambient temperature.
Reset the fault
1)
.
Heat build-up at
MOVIMOT
®
drive.
Prevent heat build-up.
Reset the fault
1)
.
Drive load too high. Reduce the load on the drive.
Reset the fault
1)
.
15 24 V monitoring Voltage dip in the 24 V
supply Check the 24 V supply.
Reset the fault
1)
.
27792307/EN – 07/2022