SEW-Eurodrive MM 03D-233-00, Краткое руководство по эксплуатации

Страница: 19 / 80

4
Mechanical installation
Installation of MOVIMOT® gearmotor
Compact Operating Instructions – MOVIMOT
®
MM..D with AS-Interface
19
• The ambient temperature corresponds to the specifications in chapter "Technical
data" of the operating instructions. Note that the temperature range of the gear unit
may also be restricted, see gear unit operating instructions.
• The MOVIMOT
®
drive must not be installed under the following harmful ambient
conditions:
– In potentially explosive atmospheres
– Oils
– Acids
– Gases
– Vapors
– Radiation
– etc.
• When the drive is installed in abrasive ambient conditions, protect the output end
oil seals against wear.
4.4 Installation of MOVIMOT
®
gearmotor
Installation of MOVIMOT® gearmotor
4.4.1 Installation tolerances
The following table shows the permitted tolerances of the shaft ends and flanges of
the MOVIMOT
®
drive:
Shaft end Flange
Diameter tolerance according to EN 50347
• ISO j6 with Ø ≤ 26 mm
• ISO k6 with Ø ≥ 38 mm up to ≤ 48 mm
• ISO m6 with Ø > 55 mm
• Centering bore in accordance with DIN
332, shape DR..
Centering shoulder tolerance in ac-
cordance with EN 50347
• ISO j6 with Ø ≤ 250 mm
• ISO h6 with Ø > 300 mm
27792307/EN – 07/2022