SEW-Eurodrive MM 03D-233-00, Краткое руководство по эксплуатации

Страница: 73 / 80

7
Service
Error list
Compact Operating Instructions – MOVIMOT
®
MM..D with AS-Interface
73
Code Error Possible cause Measure
84 Thermal
overload
of motor When the MOVIMOT
®
in-
verter is installed close to
the motor, motor protection
active.
Set DIP switch S1/5 to "ON".
Reset the fault
1)
.
The performance level is
set incorrectly for the com-
bination of MOVIMOT
®
in-
verter and motor.
Check the setting of DIP switch S1/6.
Reset the fault
1)
.
Ambient temperature too
high. Lower the ambient temperature.
Reset the fault
1)
.
Heat build-up at
MOVIMOT
®
drive.
Prevent heat build-up.
Reset the fault
1)
.
Motor load too high. Reduce the load on the motor.
Reset the fault
1)
.
Speed too low. Increase speed.
Reset the fault
1)
.
If the error is signaled just
after the first enable signal. Check the combination of motor and
MOVIMOT
®
inverter.
Reset the fault
1)
.
The temperature monitor-
ing in the motor (TH wind-
ing thermostat) has tripped
when using a MOVIMOT
®
inverter with the selected
additional function 5.
Reduce the load on the motor.
Reset the fault
1)
.
89 Brake overtempera-
ture Thermal overload of brake
coil Extend the ramp time.
Reset the fault
1)
.
Brake coil is defective. Contact SEW-EURODRIVE Service.
Brake coil and braking re-
sistor connected. Connect either brake or braking resistor to
drive.
Brake coil incorrectly con-
nected See chapters "Connection of MOVIMOT®
drive" and "Connecting without plug con-
nector"
Inverter does not match the
motor.
(only if error occurs after
first enable)
Check the combination of motor (brake coil)
and MOVIMOT
®
inverter.
Check/correct the settings of DIP switches
S1/6 and S2/1.
Reset the fault
1)
.
27792307/EN – 07/2022