Servomex SERVOPRO FID, Руководство оператора

Страница: 27 / 67

SERVOPRO FID Online Total Hydrocarbons Analyser
SERVOPRO FID 01000001A rev:5 25
occurs, 4-20 mA analogue
output is set below 4 mA.
3. HIGH : If a system error
occurs, 4-20 mA analogue
output is set above 20 mA.
Alarm #1 ppm 0-1000 Alarm #1 set point. If the
calculated impurity is over this set
point, an alarm #1 is generated.
Alarm #1 must always be smaller
then alarm #2. See section 6.2 for
more information.
Alarm #2 ppm 0-1000 Alarm #2 set point. If the
calculated impurity is over this set
point, an alarm #2 is generated.
See section 6.2 for more
information.
Auto-ignition 1-5 This is the number of times that
the analyser will try to restart the
flame if the flame goes out. See
section 6.4.1.
Table 16 : Configuration parameters
Parameter Range Description
Ethernet
enabled
YES : Analyser can be remotely controlled
NO : It is impossible to get connected to the
SERVOPRO FID.
DHCP
enabled
YES : DHCP is on.
NO : SERVOPRO FID uses a static IP address.
IP 0-255 If DHCP is enabled, the field is set read-only.
Otherwise, user can set the static IP.
Mask 0-255 If DHCP is enabled, the field is set read-only.
Otherwise, user can set the network mask.
Gateway 0-255 If DHCP is enabled, the field is set read-only.
Otherwise, user can set the network gateway.
MAC This field is read-only. This is the analyser’s MAC
address.
Table 17 : Connectivity parameters