Sentryway CurveTrack, Руководство по установке системы

Страница: 64 / 70

VIDEOSURVEILLANCE SYSTEMS
SENTRY
WAY
®
CT V2 001
Page 64 of 70
System Installation Guide
12.2.5
12.2.6
12.2.7
12.2.8
12.2.9
Remove the Nylock nuts securing the bumper stop bracket to the end rail coupler, and remove
the bumper stop bracket, the extension bars, and the RF Adapter PCB from the rail as a single
unit.
Raise the carriage so it is level, and the drive roller is toward the front.
Gently begin to insert the carriage so that the front idler wheels rest on the lower edges of the
plastic track.
Use your fingers to press and hold the brushes down in the brush holders.
Continue to guide the carriage into the system run until the rear idler wheels are resting on the
lower edges of the track. Push the carriage up the track until the rear guide wheels are inside the
enclosure. At this point, verify that thefour brushes are contacting the copper conductors.
If a defect is noted during the preceding steps, or if the carriage does not perform as indicated,
the problem must be identified and corrected before the system is energized.
Reinstall the bumper stop bracket, RF Adapter PCB, and extension bars as a unit. Secure the
assembly with the four Nylock nuts holding the bracket and the two screws with washers joining
the extension bars to the conductors.
Reinstall the end cap, or Power End Cap, as applicable, and re-connect system wiring removed in
step 13.2.2.
Reinstall the foam bumper against the bumper stop bracket.
12.3.1
Walk the carriage slowly down the full length of the system run with a flashlight and observe the
following:
a. The drive roller should always be rotating — not skidding and not stopping (which would
indicate that the roller is not in contact with the plastic track).
b. All the idler wheels must rotate freely.
12.3 Inspecting the system run
The carriage must smoothly traverse the entire length of the system
run with no resistance caused by factors such as, plastic track warpage,
rail section misalignment, copper conductors not fully seated, etc.
NOTE
12.3.2
12.3.3
12.3.4
12.3.5