Sentryway CurveTrack, Руководство по установке системы

Страница: 63 / 70

VIDEOSURVEILLANCE SYSTEMS
SENTRY
WAY
®
CT V2 001
Page 63 of 70
System Installation Guide
12. Installing the carriage
12.1 Carriage inspection
12.2 Installing the carriage in the system run
CAUTION
CAUTION
CAUTION
To avoid damaging the carriage, lift
the top foam insert straight upwards.
12.1.2
12.1.3
12.2.1
12.2.2
12.2.3
12.2.4
12.1.1
Remove the carriage from its plastic bag and place the carriage on the protective padding in the
same relative position in which it will be installed.
Inspect the carriage for obvious damage and immediately report any defects.
Remove the foam bumper from the service end of the system run.
Disconnect system wiring routed through the end cap cable bushing.
Unscrew the two captive fasteners and remove the Power End Cap, if installed, from the service
end of the system run (the RF Adapter PCB end of the rail).
Remove the two screws with washers securing the extension bars to the copper conductor end
plugs.
Separate the preformed foam packaging inserts and remove the carriage.
Any time you lift the carriage, it must be supported with both hands.
Lift the carriage by the frame ONLY! Do not apply any lifting forces to
the pan and tilt assembly or to the electronics enclosure. Do not rest the
carriage on the brushes, pan and tilt assembly, limit switch, or slip ring.
If the carriage must be rested on a hard surface, lay it GENTLY on its
side. Alternatively, lean the carriage on end against the wall.
If applicable, disconnect the 24VDC Output cable from the RF
Adapter PCB before removing the Power End Cap from the rail
in step 13.2.3.