Sentryway CurveTrack, Руководство по установке системы

Страница: 51 / 70

VIDEOSURVEILLANCE SYSTEMS
SENTRY
WAY
®
CT V2 001
Page 51 of 70
System Installation Guide
6.7 Guy wire suspension
Figure 6-2 shows the recommended method for stabilizing a CurveTrack®™ system run with a threaded rod
drop of 1.5 meters or less.
NOTE
Guy wires must be used in both the center, and at each
end, of the rail for systems up to 76 meters in length.
An another set of guy wires must be added for each
additional 30 meters of length.
6.7.1
6.7.2
6.7.3
6.7.4
Slide M10 channel lock nuts (1, Fig. 6-2) into rail section mounting channels
near each end of the system run and, if needed, at the center.
Attach the following components: M10 square washer (2, Fig.6-2), M10 flat washer (3, Fig. 6-2),
M10 spring lock washer (4, Fig. 6-2), M10 x 1.5 hex nut (5, Fig. 6-2), M10 x 1.5 x 50mm eye bolt
(6, Fig. 6-2), quick link (7, Fig. 6-2), midget– eye turnbuckle (8, Fig. 6-2), 1.5mm aircraft cable
(9, Fig. 6-2), and 1.5mm wire rope clips (10, Fig.6-2).
Secure the free end of the cable with U – bolts.
Run the guy wires on a 45 degree angle from the system run, as shown in Figure 6-2.
CAUTION
Tighten turnbuckles until cables are taut,
but not so tight as to alter the alignment of
the rails.