Sentryway CurveTrack, Руководство по установке системы

Страница: 42 / 70

VIDEOSURVEILLANCE SYSTEMS
SENTRY
WAY
®
CT V2 001
Page 42 of 70
System Installation Guide
CAUTION
Raising and attaching rail sections require a minimum of two persons.
At exceptionally high installations, or when there are large, immovable
objects beneath the erection site, power lifts or scaffolding may be required.
6.3.3
6.3.4
6.3.5
6.3.6
Connect threaded rods to rail sections. Refer to paragraph 6.4 or 6.5, as applicable.
Check alignment of rail sections. Refer to paragraph 6.6.
Raise the next pair of rail sections to the far end of the first or previous rail sections, making sure
that they are kept horizontal. As the installer holds the mating end of the next pair of rail sections
in position, snap a rail section coupler over the adjoining rail sections and secure it using the
supplied nylon insert lock nuts
Tighten the nylon insert lock nuts securing each rail section coupler.
6.4 Connecting Rail section to threaded rod assemblies - Method 1
NOTE
Guy wires (refer to paragraph 6-7) are always required
in order to stabilize the system run. A 7.5m rail will need
two guy wires at each end and another pair in the center.
Two more guy wires will be needed for each additional 3m
of rail. To accommodate fastening the guy wires, insert the
associated hardware in the rails a t t h i s p o i n t i n t h e
i n s t a l l a t i o n
If M10 channel lock nuts (11, Fig. 5-3) or (12, Fig. 5-2) have been attached to threaded rods or turnbuckles,
they must be carefully slid into the mounting channels of the rail section couplers. Do not exert excessive force
on the rod assemblies, as that could bend them out of alignment.
Using a level, adjust threaded rods so that they are plumb and parallel to each other.