STP-H803/H1303 Series Instruction Manual
3 Unpacking
Installation
3.1
Unpacking the STP Pump and the STP Control Unit
Check the following before unpacking the STP pump and STP control unit.
•
Check the package for bruises, breakage, wetness, and other.
If there is any abnormality/error or it is judged necessary to return the
product, contact BOC Edwards or the selling agency.
•
Check the contents of the package.
See Section 3.2, "Accessories."
◇
The net weight of the STP pump is approx. 39 kg. Use a crane or
other appropriate means to lift the STP pump.
Lift the STP pump with an eyebolt or a similar tool that uses the
fitting hole attached to the inlet port flange.
Lift it with the aid of a suspension tool under the base when
installing the STP pump without fitting hole.
◇
Observe national laws/regulations, safety standards and so on when
lifting the STP pump.
◇
Use a crane or other appropriate means sufficient enough to
withstand the load when lifting the STP pump.
◇
Always lift the STP pump in stable places free of excessive shock or
vibration to prevent it from shaking or dropping.
◇
Have at least two people lift the STP pump when doing so by hand.
◇
Be careful not to scratch the flange of the STP pump.
Before installing the STP pump, check whether or not there are
scratches on the surface.
◇
It is recommended to keep the packaging materials, such as the
corrugated fiberboard container and cushioning material for possible
reuse.
3-1
