STP-H803/H1303 Series Instruction Manual
◇
When removing or installing the pump or at maintenance and
inspection, follow the precautions below. Failure to do so might hurt
your back or cause injuries due to occurrence of an accident such as
fall.
•
Use a crane or the like when lifting the heavy product of 18kg or
more.
•
When lifting by hands for unavoidable reason, two or more people
must always conduct it.
•
When lifting STP control unit with handles, support bottom of STP
control unit, do not have only handle.
◇
Install the STP control unit not only by fitting it with the front panel
fitting screws but also by supporting it from the bottom side.
Fitting the STP control unit with the screws only cannot sustain its
weight, and therefore resulting in product damage.
◇
Always use the STP pump and STP control unit with same model
name, which are specified on their own nameplate. If you plan to
use the units having different model names, an error massage is
indicated and they may not be used. In the latter case, contact
Service office. If you plan to use the units having the same model
name but different serial numbers, an error message is indicated
when they are used without tuning. And, the tuning is necessary
when the length of the STP connection cable is changed. They may
not function normally when they are used without tuning. Once
tuning is completed, re-tuning is not required unless the
configuration (the STP pump serial number, the STP control unit
serial number, and the STP connection cable length) is changed.
◇
Use the STP connection cable that BOC Edwards has specified.
The use of different cables may result in product damage.
◇
Connect the cables securely. NEVER bend nor place heavy objects
on the cable. Doing so may result in electric shock or product
damage.
◇
NEVER remove the splinter shield from the STP pump. Doing so
may result in product damage.
◇
DO NOT put foreign objects into the STP pump. Doing so may
result in product damage.
◇
Always use the power voltage specified on the nameplate for the
primary power voltage of the STP control unit. Wire the power cable
securely. Incorrect wiring may result in electric shock or product
damage.
◇
The wipes used for clean the flange of the pump might become
hazardous waste depending upon the solvent (alcohol). Dispose of
the contaminated wipes appropriately according to the regulations of
each national and/or local government.
4
