SDKELI KS06 AOPD Series, Руководство по эксплуатации

Страница: 52 / 64

- 48 -
In general, NC contacts should not be used as the control contact for safe purpose!
Our company will not be responsible for control failure resulted by poor contact or disconnection of the
circuit. Other safety measurements must be adopted when NC contacts have to be connected into the
circuit.
WARNING
Realization of muting function
1. If the muting function is realized by machine itself, no additional wiring is needed;
2. If the muting function is realized with the help of AOPD, connect one pair of normal open contact
points of cam switch with NO contacts in-parallel, as shown in Fig 2.21.
Fig 2.21 The muting function is realized by OSSD
To avoid an accident, the cam switch must be adjusted to the accurate angle!
WARNING
The transmission cables between CPSII and emitter/receiver are both 5-core shielded cables; the
two terminals of transmission cable are all connected by 7 -core multipin connectors.As for single-side
protection, two transmission cables can be plugged at will. As for double-side protection, emitter/receiver
from one side must be plugged into 7-core sockets of the same side (A or B), as shown in Fig2.22.
Fig 2.22 Wiring illustration of CPSII controller
Special tool is needed to take out the fuse because of the embedded knob in the socket.
Operators must not change the fuse when unauthorized!
CAUTION
If transmission cable or power cable is tightened, the connector may be broken by shock of the
cable. The cable at the end of connector should be relaxed properly after wiring. Refer to Fig 2.29.
CAUTION