SDKELI KS06 AOPD Series, Руководство по эксплуатации

Страница: 43 / 64

- 39 -
4) Double-arm side mounting-T-groove (SCT)
Fig2.11 Double-arm side mounting-T-groove(SCT)
Fig 2.11.A
Fig 2.11.B Fig 2.11.C
Emitter/Receiver is fixed on the machine tool through an adjustable double-arm-mounting support.
This way is generally applied to open press and four column hydraulic press. The form of installation is
shown in Fig2.11.
1. According to the safety distance and relative altitude height calculated in advance, select proper position
from two sides of machine tool, drill and tap according to dimensions shown in Fig2.10.A. Fix the support
seat onto the machine bed piece by two M8×25 inner hexagon screws.
2. Insert double-arm pipe into the round hole of support seat, adjust it to be worktable of machine tool,
tight properly the two M8×25 inner hexagon screws.
3. Fix the Q-clamp onto the emitter and receiver through T-bolt.
4. Fix the emitter on the double-arm pipe through Q-clamp, adjust the height of emitter to the requirements
of the position, tight properly the tightening screws on the Q-clamp.
5. Fix the receiver on the double-arm pipe through Q-clamp, adjust the height of the receiver with the
emitter at the same height, tight properly the tightening screws on the Q-clamp.
6. Adjust the position of emitter and receiver, including safety distance, relative altitude height and
feathering angle, make them parallel, corresponding, aligned.
7. Fasten all mounting screws after start-up test.
①
Emitter/Receiver
②
Support
③
Double-arm pipe
④
Q-clamp
⑤
T-bolt--M6×24
⑥
M6 hexagon nut, Φ6 elastic/plain washer
⑦⑧
M8×25 inner hexagon screw
、
Φ8 elastic washer
⑨
M5×25 inner hexagon screw
、
Φ5 elastic washer
、
M5 square nut