SDKELI KS06 AOPD Series, Руководство по эксплуатации

Страница: 41 / 64

- 37 -
Fig 2.9.C
Fig 2.9.D
Emitter/Receiver is fixed on the machine through an adjustable pipe-mounting support. This way is
generally applied to open press and four column hydraulic press. The form of installation is shown in
Fig2.9.
1. Install the adjustable pipe-mounting support
● Select proper position from two sides of machine, drill and tap according to dimensions shown in
Fig2.9.A. Fix the bracket seat onto the machine bed piece by two M8×20 inner hexagon screws.
● Fix the bracket arm on the bracket seat by one M16×45 hexagon screw.
● Insert steel pipe into the round hole of bracket arm, adjust it to a proper height, tight properly the M8×25
inner hexagon screw.
2. Install the two KS pipe-mounting fixing clamps on the steel pipe, adjust the lower clamp to a proper
position, tight properly the M5×25 inner hexagon screw.
3. Fit Emitter/Receiver, KS06 upper vibration-reducer and KS06 lower vibration-reducer together, and
make sure that the KS06 lower vibration-reducer is on the side of the Emitter/Receiver with multipin
connector for transmission cable.
4. Mount the Emitter/Receiver with vibration-reducer on the KS pipe-mounting fixing clamps fixed on the
pipe-mounting support. Fix the KS pipe-mounting fixing clamps through M5×25 inner hexagon screws.
5. Adjust the position of emitter and receiver, make them parallel, corresponding, aligned.
6. Fasten all installed screws after start-up test.
3) Double-arm side mounting
-
with reducer (SCJ)
Fig2.10 Double-arm side mounting-with reducer(SCJ)