SDKELI KS06 AOPD Series, Руководство по эксплуатации

Страница: 49 / 64

- 45 -
10) Scatter shield column mounting (FL)
Fig 2.17 Scatter shield column mounting(FL)
①
M8×30 inner hexagon cone end set screw
②
M12×120 expansion bolt
③
Floor scatter shield
④
Floor column base
⑤
Floor column base plate
Fig 2.17.A Fig 2.17.B
1. Use M6 × 20 inner hexagon screws to fix the Floor scatter shield
③
to the Floor column base
④
and
tighten the screws.
2. Select the appropriate location, use M12×120 expansion bolt
②
to fix Floor column base
④
and Floor
column base plate
⑤
to the ground, adjust the direction of the floor bracket and pre-tighten the expansion
bolts.
3. Adjust M8×30 inner hexagon cone end set screws
①
to make the bubble in the center of the gradi-enter
on the column base.
4. Adjust the Reflector I to make its reflecting surface to the transmission surface of the emitter at an angle
of 45 °, then adjust the Reflector II and Reflector III in turn, to make the reflecting surface of Reflector
II perpendicular to the reflecting surface of Reflector I and to make the reflecting surface of Reflector III
perpendicular to the reflecting surface of Reflector II.
5. Power on light debugging. With the aid of the collimation device, adjust the Emitter, Reflector I,
Reflector II, Reflector III and Receiver initially positioned, to make the collimated light beam emitted by
the collimation device being reflected by the three reflectors on the transmission surface of the receiver .
6. Adjust the floor bracket assembled with the receiver until all individual indicators on the receiver turn off
and keep the floor bracket in this position, then adjust it lightly to stabilize the light-passing state.
7. Tighten the expansion screws completely.