SDKELI KS06 AOPD Series, Руководство по эксплуатации

Страница: 48 / 64

- 44 -
9) Scatter shield double-arm mounting (SF)
①
Emitter/Receiver
②
Scatter Shield
③
T-bolt-M6×14.5
④
M6 hexagon nut, Φ6 elastic/plain washer
⑤
T-bolt-M6×24
⑥
M5×25 inner hexagon screw, Φ5 elastic washer
⑦
M5 square nut
⑧
Q-clamp
Fig 2.16 Scatter shield double-arm mounting (SF)
1. According to the safety distance and relative altitude height calculated in advance, select proper position
from two sides of machine tool, drill and tap according to dimensions shown in Fig2.16.B. Fix the support
seat onto the machine bed piece by two M8×25 inner hexagon screws.
2. Insert double-arm pipe into the round hole of support seat, adjust it to be worktable of machine tool,
tight properly the two M8×25 inner hexagon screws.
3. The emitter and receiver are fixed on the T-slot inside the scatter Shield by ZC-mounting bracket, upper
and lower shock absorbers, and T-bolt.
4. Fix the Q-clamp onto Scatter Shield through T-bolt-M6×24 and M6 hexagon nut.
5. Fix the emitter Scatter Shield on the double-arm pipe through Q-clamp, adjust the height of emitter to
the requirements of the position, tight properly the tightening screws on the Q-clamp.
6. Fix the receiver Scatter Shield on the double-arm pipe through Q-clamp, adjust the height of the receiver
with the emitter at the same height, tight properly the tightening screws on the Q-clamp.
7. Adjust the position of emitter and receiver, including safety distance, relative altitude height and
feathering angle, make them parallel, corresponding, aligned.
8. Fasten all mounting screws after start-up test.
Fig 2.16.A Fig 2.16.B