SATEL ACU-280
5
3.2 DIP-switches
Using the DIP-switches, you can:
define the controller operating mode,
set the controller address (operating mode: expander of wireless devices for the
INTEGRA / INTEGRA Plus control panel).
3.2.1 Selecting the controller operating mode
Fig. 2. Switches defining the controller operating mode.
Switches 9 and 10
(Fig. 2) define the controller operating mode – see Table 1.
DIP-switch
Controller operating mode
9
10
Expander of wireless devices for the INTEGRA / INTEGRA Plus
control panel
OFF
OFF
Expander of wireless devices for the VERSA / VERSA Plus /
VERSA IP control panel
OFF
ON
Table 1.
3.2.2 Address setting [expander of wireless devices for the INTEGRA /
INTEGRA Plus control panel]
Fig. 3. DIP switches for setting address when the controller is connected to the INTEGRA /
INTEGRA Plus control panel.
Switches 1-5
(Fig. 3) are used to set the address when the controller is connected to the
INTEGRA / INTEGRA Plus control panel (in the other operating modes, the settings of
switches 1-5 are irrelevant). Numerical value is assigned to each switch. In OFF position, the
value is 0. Numerical values assigned to individual switches in ON position are presented in
Table 2. The sum of numerical values assigned to switches 1-5 constitutes the address set in
the device. The address must be different than that set in the other devices connected to the
expander bus of the control panel.
