20 ACU-280
SATEL
No automatic update of wireless devices firmware
[No updates] – if this option is enabled,
the firmware of wireless devices registered in the controller is not updated automatically
(see “Updating the firmware of ABAX 2 wireless devices” p. 41).
User can replace VERSA-LCDM-WRL battery
– if this option is enabled, all users can
replace battery in the VERSA-KWRL2 wireless keypads (for 3 minutes after the code is
entered and confirmed with the
key, the status of tamper switch will not be monitored
on the keypad that was used to enter the code). If the option is disabled, the battery can
only be replaced by the users who have access to the “Replace bat.” function in the
“0.Service” submenu.
Fig. 11. DLOADX
program: parameters and options of the controller connected to VERSA /
VERSA Plus / VERSA IP control panel.
7.2 Functions
Test mode
– to carry out diagnostics / service work, you can start the test mode in the
ABAX 2 system. When the system is running in the test mode:
– detector LEDs are enabled,
– tamper signaling in the sirens is blocked.
The command to start/end the test mode is sent during periodical communication, i.e. with
delay whose duration depends on the frequency of periodical communication. The test
mode will be disabled automatically 30 minutes after:
– starting the test mode from the DLOADX program (the countdown of 30 minutes runs
from exiting the controller settings),
– exiting the service mode in the INTEGRA / INTEGRA Plus / VERSA / VERSA Plus /
VERSA IP control panel,
– closing the ABAX 2 Soft program.
As required by EN50131, the level of radio signal sent by wireless devices is lowered
when the system is running in the test mode.
Synchronize
– the function does not apply to the ABAX 2 system.
