53
Chapter 4. How to Operate
4.1 Functions for Remote Controller
전
중
진
립
진
후
10
속
고
좌
저
속
10
중
2
0
립
0
40
30
타
40
타
20
우
3
0
4.2 How to operate for Remote Contoller
To remote control engine, first after install it, complete the initial set and function set, the following
step should be taken.
Check if clutch of remote and position of governor are same level of manual lever.
Check if lock device on governor lever of manual lever is released. (If lock device is
fastened, it will cause trouble of electric lever.)
Switch on power switch of electric lever (separate installed switch).
If Buzzing is for 2 seconds and stop, that is normal. Control engine as clutch and
governor controller by means of remote controller use.
If buzzing is activating constantly above 4 items, check if manual lever and remote
controller position are same level. Buzzer would be stepped and operated normally.
Clutch controller is operating regardless of revolving speed. Governor controller should
be handled slowly due to controller revolving speed affect engine revolving speed.
Caution After checking engine revolving speed(auto check), control clutch. If it is more
than 10% at low speed, set engine revolving speed to low speed. After 2 seconds, set clutch
setting condition.
< Figure 4-1. Remote Controller of RC-30A >
Clutch controller
: Locating in the middle is
neutral, turning D this to clockwise moving
forwards, and turning counter clockwise allows
moving backward.
②
②
②
②
Governor controller
: Turning this to
clockwise makes speed lowering and turning
this to counter clockwise makes speed faster.
③
③
③
③
Steering controller
: When auto steering
controller installed, this works as steering
controllers, so the direction of
.
N
.
54
Caution If clutch is AHEAD or ASTERN but NEUTRAL, after that set clutch approximately
after 1 second, set engine revolving speed automatically at same level of governor control
position of remote control. Approximately, as 10% (Governor slow speed to full speed
one-hundredth percentage) is increased at 1 second, full revolving speed is increased at 5
seconds.
However, if you turn governor controller in auto accelerated, it will set current controller
position.
Caution As using manual control on remote control, power off ,then manual control by
manual lever is available.
Power on, compare and check between remote control, governor control position and manual
clutch, governor lever position (auto check). If that is differently positioned, buzzer would be
ringing. Remote doesn't control in the time of ringing and only geared by manual lever.
(Buzzer would be stopped if it is united and controlled by remote control)
