43
2.3 Cable connection to manual lever
Check the installed manual lever first to ensure highest performance when it is connected with
electronic lever through the control cable.
< Figure 2-4. Cable connection to manual lever >
Clutch lever
Governor lever
Connect the control cable to the inside
of electronic lever to reduce the up and
down moving space
< Figure 2-3. Clutch adjust of control cable >
Clutch lever
(forward,Neutral,Backward)
Governor lever
(Speed adjust)
Cable connect point on
Electronic lever side
Cable connect point
on engine side
Electronic lever
①
②
Vessel engine
44
For best performance of motion of manual clutch lever , link point of "①" on above
picture should be selected properly.
a) When the manual clutch lever is on forward position, location of the lever has to
be forwarded by pushing it.
b) b) When the manual clutch lever is on neutral position, location of the lever has
to be in the middle.
c) c) When the manual clutch lever is on reverse position, location of the lever has
to be backed by pulling it.
For best performance of motion of manual governor lever , link point of "①" on above
picture should be selected properly.
a) When maximum speed, location of the lever has to be forwarded by pushing it.
b) When minimum speed, location of the lever has to be backed by pulling it
Position adjustment of manual lever can be done by selecting a link point of "①" and
minute adjustment can be done by turning the linking device of the control cable
Cable link point of the electronic lever side has to be same as able link point of the
engine side.
2.4 Wiring Connection
Please observe the follow instruction before electric wiring. If fail to meet this instruction, electric
shock or damage of equipment can occur.
Power should be off.
Check the terminal plate ( + , - ) of main unit and don`t connect it reversely.
☞ polarity : white colour -> [ + ] , black colour -> [ - ]
Check terminal mark and wire colour first and then fix screws in case of the connection
of junction terminal. ☞ wrong connection could cause a damage on the unit
Check whether there is any contact among terminals after completing electric wiring
Cable shield, which is connected to remote control or auto steering controller has to be
connected to terminal "C" of electronic lever.
Cut it out in proper length when a cable is longer than needed. Use same kind of cable
when a cable is shorter than needed.
Install "power switch" at a place where is easy to access. ☞ recommendable place is near
the manual lever because it is necessary to switch on/off for converting of manual
control or Remote control .
Install the unit away from radio transceivers such as SSB, VHF radio.
☞ Keep away electric wiring of engine control from electric wiring of radio transceivers
It is because the operating of unit can be interfered by radio transceivers
Caution If power is on when the connection of polarity is reverse , fuse will be broken and
if the installed fuse was not a standard one , it could cause a damage on the unit.
