Sakai SW800-II, Руководство по ремонту

Страница: 233 / 258

10-059
TROUBLESHOOTING
2-7-2. Illumination of combination meter does not turn on
Check that headlamps turn on.
Reference Fig.: 2-7-1
Check point Check/Cause Action
1. Harness Measure resistance between lamp switch terminal 4 outlet
wire LgB and combination meter connector terminal wire
No.43 LgB.
Standard resistance: 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.
2. Combination Meter (1) When starter switch is ON, measure voltage between
combination meter terminal wires and ground terminal
wire.
Terminal wire R (battery terminal)
and terminal wire B (ground terminal)
Terminal wire P (starter switch terminal)
and terminal wire B (ground terminal)
Standard voltage: 12 V or more
(2) When starter switch is ON and lighting switch is ON,
measure voltage between combination meter terminal
wire WR (backlight terminal) and chassis ground.
Standard voltage: 12 V or more
If above items (1) and (2) are OK and combination meter
lamp does not turn on, combination meter is faulty.
•
Replace combination
meter.
2-7-3. Combination meter warning lamp or indicator lamp is abnormal
Reference Fig. : 2-7-1
Check point Check/Cause Action
1. Combination Meter (1) When starter switch is ON, measure voltage between
combination meter terminal wires and ground terminal
wire.
Terminal wire R (battery terminal)
and terminal wire B (ground terminal)
Terminal wire P (starter switch terminal)
and terminal wire B (ground terminal)
Standard voltage: 12 V or more
(2) When starter switch is ON, check that parking brake
indicator lamp, hydraulic filter warning lamp, oil
pressure warning lamp and charge warning lamp
illuminate and then go out after starting engine.
If above item (1) is OK and item (2) is NG, combination
meter is faulty.
•
Replace combination
meter.
•