Sakai SW800-II, Руководство по ремонту

Страница: 207 / 258

10-033
TROUBLESHOOTING
2-5. Vibrator
Check following items before troubleshooting.
No blown fuses.
Set throttle switch to “FULL” position.
Vibrator switch (F) and (R) on control panel must not be OFF.
2-5-1. No vibration occurs
F-R lever vibrator switch must be ON.
Vibration mode selector switch must be CONT.
Reference Fig.: 2-5-1
Check point Check/Cause Action
1. Vibrator Solenoid
(F) and (R)
Disconnect harness and measure resistance of coil.
Standard resistance: 10.3
± 0.52
Ω
If measured resistance is abnormal, vibrator solenoid is
faulty.
•
•
Replace vibrator solenoid
(F) or (R).
2. Vibrator Switch
(F) and (R)
(1) When starter switch is ON, measure voltage between
vibrator switches terminal 1 or 4 inlet wire Br and
chassis ground.
Standard voltage: 12 V or more
(2) When starter switch is ON, measure voltage between
vibrator switches terminal 2 or 5 outlet wire and chassis
ground.
Vibrator switch terminal 2
Front side: LR, Rear side: LgY
Vibrator switch terminal 5
Front side: GL, Rear side: YR
Standard voltage: 12 V or more
If above item (1) is OK and item (2) is NG, vibrator switch
is faulty.
•
Replace vibrator switch
(F) or (R).
3. F-R Lever Vibrator
Switch
(1) When starter switch is ON, measure voltage between
F-R lever vibrator switch terminal NO inlet wire G and
chassis ground.
Standard voltage: 12 V or more
(2) When starter switch is ON, measure voltage between
F-R lever vibrator switch terminal COM outlet wire Br
and chassis ground.
Standard voltage: 12 V or more
If above item (1) is OK and item (2) is NG, F-R lever
vibrator switch is faulty.
•
Replace F-R lever
vibrator switch.
4. Vibration Mode
Selector Switch
(1) When starter switch is ON, measure voltage between
vibration mode selector switch terminal 1 inlet wire YW
and chassis ground.
Standard voltage: 12 V or more
(2) When starter switch is ON, measure voltage between
vibration mode selector switch terminal 3 outlet wire G
and chassis ground.
Standard voltage: 12 V or more
If above item (1) is OK and item (2) is NG, vibration mode
selector switch is faulty.
•
Replace vibration mode
selector switch.
5. Harness Connecting
Between Terminals
Measure resistance of harness connecting between
terminals.
Standard resistance: 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.
•
•
•
•
•