Sakai SW800-II, Руководство по ремонту

Страница: 243 / 258

10-069
TROUBLESHOOTING
2-7-10. Vibrator indicator lamp does not light 2/2
Check that vibration can be activated.
Reference Fig.: 2-7-2
Check point Check/Cause Action
3. Harness Connecting
Between Terminals
Measure resistance of harness connecting between
terminals.
Standard resistance: 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.
2-7-11. Parking brake indicator lamp does not light
Reference Fig.: 2-7-2
Check point Check/Cause Action
1. Parking Brake Switch When starter switch is ON, measure voltage between
parking brake switch terminal 4 inlet wire L and chassis
ground.
Standard voltage: 12 V or more
If above measurement is OK and parking brake indicator
lamp does not light even though parking brake switch is
applied/release, parking brake switch is faulty.
•
•
Replace parking brake
switch.
2. Combination Meter (1) When starter switch is ON, measure voltage between
combination meter terminal wires and ground terminal
wire.
Terminal wire R (battery terminal)
and terminal wire B (ground terminal)
Terminal wire P (starter switch terminal)
and terminal wire B (ground terminal)
(2) When starter switch is ON, measure voltage between
combination meter terminal GR (parking brake terminal)
wire L and chassis ground.
Standard voltage: 12 V or more
If above item (1) is OK and item (2) is NG, combination
meter is faulty.
•
Replace combination
meter.
3. Harness Connecting
Between Terminals
Measure resistance of harness connecting between
terminals.
Standard resistance: 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.
•